The current capacity of the power contacts is 10 A max. Self-cleaning power jumper contacts (P.J.C.s) ensure safe connections. The voltage is automatically supplied when the I/O modules are snapped together.
A reliable contact is assured by the gold plated, self cleaning slide contacts. The control electronics in the bus modules are powered by snap-fit mounting the bus modules using the internal bus contacts. If the sum of the internal power consumption of all bus modules exceeds this value, it is necessary to add additional internal system supply modules (Order-No. This value depends on the type of Coupler/Controller. The power supply is limited to a maximum value. The internal bus includes the internal communication between the coupler/controller and the bus modules as well as the power supply for the bus modules. Electrical isolation from the external fieldbus system depends on the type of Coupler/Controller. The system supply voltage (24 V DC) is filtered with a voltage regulator before powering the coupler electronics as well as to the internal bus. Otherwise the results could be wrong or the module could be destroyed. The ground (earth) field side contact should be disconnected when testing the isolation. The supply modules + and – which are permanently integrated on the buscouplers, can be supplied with 24 V DC only.ġ20 V AC and 230 V AC can only be supplied via modules 750-609, 750-611 and 750-612! These fluctuations could cause a voltage interruption on the primary side, a secondary side overload or the switching of ”non quenched" inductance or capacitance. This module serves to regulate a noisy 24 V DC voltage supply and to keep the ripple voltage within specified limits. 288-824) was developed for the WAGO-I/O-SYSTEM. If a non-regulated power supply is used for the coupler/controller electronics 24 V voltage supply, it must be filtered through a capacitor (200 ♟ per 1 A load current). In this manner sensors and actuators can be supplied and fused by a separate voltage source. The power supply on the field side is electrically isolated from the system supply. Information on the network architecture.LON library elements for WAGO-I/O-PRO 32.Programming the PFC with WAGO-I/O-PRO 32.Configuration and programming interface.
#EXTERNAL POWER SUPPLY FOR MAC PRO CODE#
Fault message via the blink code of the I/O LED.
0 kommentar(er)
